-
东莞创亿嘉润滑油有限公司
电话：0769-81283290
联系人：刘超
手机：13725804996
企业QQ：1352876343
邮箱：1352876343@qq.com
网址：www.cyj188.com
地址：广东省东莞市南城区高新产业园区宏一路
邮编：523073
|
| 壳牌润滑油系列 > 壳牌航空润滑油 > AEROSHELL FLUID 12/AEROSHELL FLUID12 |
| AEROSHELL FLUID 12/AEROSHELL FLUID12 详细说明 （浏览1241次） |
AEROSHELL FLUID 12
AeroShell Fluid 12 is a low volatility synthetic ester oil used in aircraft
instruments and also for the general lubrication of aircraft. It is oxidation
and corrosion inhibited, and possesses good high and low temperature
characteristics.
APPLICATIONS
AeroShell Fluid 12 is used for general aircraft lubrication as well as for
aircraft gyro instrument gimbal bearings, separately lubricated high speed
turbines and compressors, aircraft air cycle equipment and electronic
equipment. AeroShell Fluid 12 is particularly suitable for use when an oil
with a low evaporation rate is required at high and low temperatures.
AeroShell Fluid 12 is a synthetic oil and it should not be used in contact
with incompatible seal materials such as neoprene or natural rubber.
Suitable seal material include Fluorocarbon (Viton). AeroShell Fluid 12 may
also affect certain paints and plastics. It is recommended that components
are evaluated for compatibility if there is any question.
SPECIFICATIONS
U.S. Approved MIL-PRF-6085D
British Equivalent DEF STAN 91-49
French Equivalent AIR 3511/A
Russian –
NATO Code O-147
Joint Service Designation Equivalent OX-14
www.shell.com/aviation
236
Other Fluids
PROPERTIES MIL-PRF-6085D TYPICAL
Oil type – Synthetic ester
Kinematic viscosity mm
2
/s
@ 54.4°C 8 min 8.2
@ −53.9°C 12000 max 11000
Flashpoint
Cleveland Open Cup °C 185 min 220
Pourpoint °C −57 max Below −60
Total Acid Number mgKOH/g – 0.20
Relative Density at 15.6/15.6°C – 0.925
Evaporation loss in 22 hrs
at 120°C % m 1.80 max 1.50
Colour ASTM – < 0.5
Oxidation and corrosion stability
168 hrs @ 135°C
– metal weight change Must pass Passes
– viscosity change @ 54.5°C ± 5 0.5
– total acid number change
mgKOH/g 0.5 max 0.1
– insolubles mg/100ml – 1.0
Low temperature stability Must pass Passes
Corrosivity Must pass Passes
A viscosity/temperature curve is shown at the end of this section |
|
|
